Integrations and Customizations
The benefits of integration and work from the coil allows savings of up to 30%
They range from saving in material , on transport , on time , on lock , in the number of operators that must operate the machine, in the space that occupies the same amount of material in the stock (coil vs sheets), until the improvement of the efficiency and the productivity .
Our machines can be equipped with any other punching machines, laser cutting, folding machines, presses, etc.
This enables a fully automated start-to-finish DONE-IN-ONE manufacturing process, exponentially improving the quality, efficiency and productivity of the process and the end product.
Our extensive experience in the design and manufacture of machinery has allowed us to design these types of lines capable of adapting to all processes.
We are at your service
Savings in raw materials
The purchase of coil instead of format implies an average saving of 5% in the cost of raw material. We take advantage of the length of the coil, thus wasting less material. In this way we will achieve a greater benefit for our final product.
Less Storage Space
The coils take up much less space than the traditional sheet metal format. They are comfortable to store now, and their handling is agile and safe.
Higher productivity
A 1-ton 1-millimeter-thick coil is 850 meters long. With an Ekicontrol cutting line we can cut 3 meter formats in less than an hour.
Straightening Quality
The quality of the straightening of our cutting lines complies with the most demanding international standards.
Flexibility
The flexibility of having circular blades implemented in the straightener module does not allow adjusting the width and making all the cuts of the coil on the same machine.
Adaptability
We can adapt all types of reception tables of formats: scissor tables, fixed tables, tables of different lengths, interchangeable to adapt to your manufacturing needs.
Application Sectors
EKICONTROL cutting lines offer important advantages and benefits for the manufacture of numerous products in different sectors
Frequently Asked Questions
Up to 3 more blades are recommended at most, although there are customers who have placed up to 5 more.
The scrap winders are used to wind the edge of the sheet that has been cleaned up. This makes it easier to roll up for later disposal.
Among others, aluminum, galvanized, pre-lacquered and stainless.
In the TWINCUT20 this process is carried out by the operator by varying the penetration of the upper straightening rollers.
We fall within the parameters of European regulations.
Yes, up to a maximum of 1550 mm.
Normally not, but when more delicate materials are to be processed, such as stainless steel, it is necessary to clean the rollers. This cleaning is carried out by the operator manually as maintenance.
Get in contact with us
A member of our team will answer you as soon as possible
